دستگاه تستر رنگ مدل EC-100یکی از ساده ترین و ارزانترین دستگاه های ضخامت سنج پوشش در دنیا میباشد که در تست رنگ اتومبیل و کارشناسی بدنه اتومبیل مورد استفاده قرار میگیرد ، قیمت مناسب ، دقت بالا ، سایز کوچک از محسنات این دستگاه تشخیص رنگ میباشد . سنسور با دقت بلای میکرونی روی آهن و آلومینیوم ضخامت رنگ را نمایش میدهد .
Economical Car Automobile Paint Thickness Tester
تلفکس فروش :
021-77130687-8
فروشگاه کالا ان دی تی
دستگاه تشخیص رنگشدگی اتومبیل EC-100
دستگاه تستر رنگ مدل EC-100یکی از ساده ترین دستگاه های ضخامت سنج پوشش در دنیا میباشد که مخصوص تست رنگ اتومبیل و کارشناسی بدنه اتومبیل مورد استفاده قرار میگیرد ، قیمت مناسب ، دقت بالا ، سایز کوچک از محسنات این دستگاه تشخیص رنگ میباشد .
Introductions This gauge is ultra low cost coating thickness gauge and can mainly be used to measure carrsquo;s paint coating thickness. It is used for non-destructive coating thickness measurement of non-magnetic coatings on steel and insulating coatings on non-ferrous metals.
Replacing the Battery Place the gauge upside down on a suitable surface, raise the lid of the compartment, remove battery, insert new battery according to the positive and negative poles and close the lid.Measurement Step Step 1. Prepare the sample to be measured. Step 2. Press POWER key to power on, and keep probe away from any metal. Step 3. Reference to the ldquo;Zero Calibrationrdquo; if need to calibrate the gauge. Step 4. Start measuring. Place the probe on the sample vertically and rapidly, and after one beep, raise the probe rapidly. Readings will be display on LCD. Step 5. Do next measurement according to step 4. Step 6. Press POWER key to power off. If not any operations within 2 min., the gauge will power off automatically.Zero Calibration a. Press and hold ldquo;ZEROrdquo; until hearing ldquo;beep...beep beep...rdquo;. The LCD will flash ldquo;ZEROrdquo; symbol. b. Place the probe on uncoated sample and raise it after one beep. c. Repeat step b several times to obtain mean value. d. Finished. Press ldquo;ZEROrdquo; to exit calibration mode.Unit Press the UNIT key to select the shown unit(mm or mils) for the readings. Probe Mode Press the MODE to select the probe mode(Including Fe and NFe). In Fe, the probe can only test on ferrous substrate. In NFe, the probe can only test on non-ferrous substrate.Auto Power off The device will power off automatically within 2 min when there are not any operations. Before power off automatically, the clock sign on LCD will flash.